trk-101-P PTZ Tracker Installation Manual Rev 1 February 2015 The contents of this guide may no
trk-101-P Installation Manual viii Avis et avertissements relatifs à la sécurité électrique Avertissement: 1. Lisez les instructions d&apos
Document Information ix Minimizing EMI and RFI When wires run for a significant distance in an electromagnetic field, electromagnetic interfer
Introduction 1 2. Introduction The trk-101-P PTZ Tracker is a single-channel, self-contained H.264 IP video analytic encoder that is designed to con
trk-101-P Installation Manual 2 2.1 Items Included in the Package The unit package contains the following items: QTY Description 1 trk-101-P PTZ
Introduction 3 Item Description RESET Button For setting the unit factory defaults, setting Technician mode, or resetting the unit. LEDs The LE
trk-101-P Installation Manual 4 2.2.2 Video Connection Panel The following is a description of the video connection panel of the unit. Figure 4
Installing and Connecting the Unit 5 3. Installing and Connecting the Unit This section describes how to install and connect the unit and includ
trk-101-P Installation Manual 6 To assemble units in a rack mount panel: 1. Remove the nut and washer from each of the two video connectors on t
Installing and Connecting the Unit 7 3.2 Connecting the Unit This section describes the procedures for connecting the unit and includes the fol
trk-101-P Installation Manual 8 Warning: 1. To prevent bodily injury or damage to the unit, use only properly rated and approved power supplie
Installing and Connecting the Unit 9 To change the unit’s IP address 1. Insert the CD included in the package in your computer’s disk drive. N
trk-101-P Installation Manual 10 6. For each unit, do one of the following: If your network uses a DHCP server: i. Select Use DHCP. ii. Clic
Installing and Connecting the Unit 11 3.2.4 Connecting the Video Source (Camera) to the Unit The unit is designed to accept a composite video s
trk-101-P Installation Manual 12 3.2.5 Configuring PTZ Camera Settings on the Encoder PTZ camera settings are configured in the Setup > Camer
Installing and Connecting the Unit 13 To connect the unit analog video output to an analog device Using video coax 75Ω cable with BNC connect
trk-101-P Installation Manual 14 Caution: To prevent damage to the unit, do not exceed the voltage and current ratings for the relay terminals
Installing and Connecting the Unit 15 3.3.2 Reset by Removing the Power Supply The unit can be reset by turning off the power and then turning
trk-101-P Installation Manual 16 Appendix The appendix contains the following sections: Technical Specifications (page 17) Connecting Leads to a
Appendix 17 A.1. Technical Specifications Following are the trk-101-P technical specifications: Video Input Channels Number of Intelligent Video
Table of Contents i Table of Contents 1. Document Information ...
trk-101-P Installation Manual 18 Physical Dimensions Dimensions (mm) 68.5 x 36 x 118 mm (W x H x D) Dimensions (in.) 2.7 x 1.42 x 4.62” (W x H x
Appendix 19 A.2. Connecting Leads to a Spring Clamp Terminal Block The unit is delivered with two terminal block connectors. The connectors enab
trk-101-P Installation Manual 20 A.3. Troubleshooting This section provides useful information and remedies for common situations where problems
Appendix 21 Problem Possible Solution Bad output video quality Check the source video signal quality by connecting an analog monitor to the
trk-101-P Installation Manual 22 A.4. N/O to N/C Relay Configuration The on-board relay in the trk-101-P provides a single contact which is by de
Contacting DVTEL 23 Contacting DVTEL To contac
trk-101-P Installation Manual ii List of Figures Figure 1: trk-101-P Unit ...
Document Information iii 1. Document Information Document Conventions WARNING and CAUTION notes are distributed throughout this document, whenever
trk-101-P Installation Manual iv Document Scope and Purpose The purpose of this document is to provide instructions and installation procedures f
Document Information v Disclaimer Users of DVTEL products accept full responsibility for ensuring the suitability and considering the role of th
trk-101-P Installation Manual vi Warning: 1. The unit’s cover is an essential part of the product. Do not open or remove it. 2. Never opera
Document Information vii Electrical Safety Notice and Warnings Warning: 1. Read the installation instructions before you connect the unit
Kommentare zu diesen Handbüchern