DVTELL Ioimage trk-101 Installationshandbuch PDF herunterladen (Seite 26)

Appendix

A.2. Connecting Leads to a Spring Clamp Terminal Block

The unit is delivered with two terminal block connectors. The connectors enable you to connect wires for

either the Relay Output or Alarm Inputs and then connect them to the unit.

Figure 10: Spring Clamp Terminal Block

To connect a wire to the spring clamp terminal block:

11. Strip the insulation form the end of each wire that is to be connected to the terminal block.

Approximately 1 cm (2.54”) of wire should be exposed.

12. With a small screwdriver, press in and hold the orange spring-clamp button next to the female

outlet where the wire will be inserted.

13. Insert the stripped end of the wire into the female outlet.

14. Release the orange spring-clamp button.

Figure 11: Connecting a Wire to a Terminal Block

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

DVTELL Ioimage trk-101 Installationshandbuch Seite 26